9048 Results
Longer sweep times in CW mode
Access the analyzer with a browser (LXI)
I want to control my HM8123 / 8118 via the built in RS232 port. Unfortunately i do not get any response from the device. What do i have to do to ensure proper communication?
FAQ: Using Individual GTEM Cells
How to calculate accuracy for the digital multimeter HMC8012.
I perform a calibration with remote commands. With the command to start the calibration sweep with a short standard I get this error message. What is the problem?
Copy the entire database from old version of ELEKTRA to the latest version of ELEKTRA
I connected my NRP Sensor to the CMA180. Unfortunetaly it is not found when opening the "Sensor" Tab. What can I do to make the sensor work?
I want to use the receiver mode of the HMS-X via remote control. Unfortunately the manual only describes how to change to the Rx Mode.
I have created limits lines and used a graph function to show it. I would like to change the color of the limit lines. Is is possible to change the color of the limit line?
Using the ZN-Z103 calibration unit with the FPC1500
How can I export the traces of a specific channel into one file, i.e. CSV?
Measuring a DC Test Item
Time Domain Scan without Autoranging
We are talking about positive and negative numbers. Which method do I have to use? I know at least three ways of handling binary data with positive as well as negative values.
Use the external SMB port of the NRPXXS(N) in trigger send mode.
What is the USB VISA address string of the NGE for remote control?
Kindly help me to run the software.After installation, I am getting error message to run the software.
Storing TOUCHSTONE
FSWP: Get the data of the grey background curve via remote control
How to set the preselector to off
ZNB/ZND - wrong connector type shown at Cal Unit Characterization
Remote control: Remote control via RS232
The export of the history to file with remote commands with the Scope Rider RTH.
For some tests a vector network analyzer is required. The Scope Suite software just supports VNAs from R&S to be connected via LAN for automated measurements. Can I use also other VNAs and do the measurement manually?
Which is the correct input impedance for our probe?
FAQ - How to connect the FPC via USB for remote control?
How can I read the equalizer file *.vae? It is possible to read the file with Matlab.
Possibility of Recording GPIB Commands?
I tried to measure the Voltage Noise of my power supply unit which is specified to the following values. My results have been much higher and I sent in the device for alignment/calibration. After getting it back I still gather the same results. Can you explain how to perform such a measurement?