9047 Results
Matlab: Remote Control example for NRP-Zxx power sensors with NI-VISA
FPC1500 - results after calibration in VNA mode
I am existing EMC32 customer. It is possible to migrate my EMC32 templates to ELEKTRA?
How can I find out that the measurement has been finished?
Number of harmonics, RTE, RTO, Power option, FAQ
FAQ. TS8997 waveform files on the vector generator not found
UNCAL message after manual changes in the Coupling menu
Unable to launch Elektra, re-install with clean up
I want to use the LCX series LCR Meter to automatically control and sort components. One of the tasks is to differentiate between the following three values of resistors: - Less than 990 Ohm, - Middle range from 990 to 1010 Ohm (1 kOhm), - More than 1010 Ohm. How can I set this measurement up and which pins do I have to use at the 15 PIN SUB-D socket at the rear side of the LCX?
EMC32, Download Transducer Factor to Test Receiver
Does the option ZNA-K1 (Spectrum analyzer mode) also work with the Millimeterwave Converters?
We want to measure the voltage of the main line with our oscilloscope.
Self Alignment via remote control via TCP/IP => 'CAL?
FAQ: Activate Logins for Different Users
Updating API macros in EMC32
FAQ: Check EMC32 Expansions
I want to connect my HE400 to my handheld devices. Unfortunately I don't know which adaptor cable I need for that task. Is there an overview available?
Is it possible to set up an IP peer to peer test using CMW500 between a corporate network and one EUT attached to an LTE cell?
I would like to measure the voltage at a certain time of a captured waveform. Do I need to use the cursor function? May I ask for the SCPI commands?
Learn how to solve the issue in case you get the error message "Application will be closed" from EMC32 Main Startup.
I have ELEKTRA dongle connected to my PC, but some of my devices from Device List are missing. Because of this I would like to simulate my Test, but the button "Simulate" is missing after Device Check.
How do I use the driver correctly?
I have set my VNA to single sweep mode and switched on averaging with a factor of 10. But when I restart the single sweep, it stops after 1 sweep and the averaging is not done.
Which Receiving Antenna is the right one?
Location of the instrument Drivers
The SCPI sequence for configuration and data query for the I/Q software interface option K11.
Multichannel audio measurements
Start-up characteristic of oscillators
ELEKTRA, pre-define scaling of the graphics
We have installed our test system with EMC32 and all devices, but NRP2 can not be set to physical from EMC32 using LAN interface.