Welcome to our webinar "Basic Introduction to the New R&S EMC Software “Elektra” the Successor of the famous R&S®EMC32".

How can I add a attenuation table to my cable, used in my measurement setup?

Use of the ESW build in Pulse Limiter, if remote controlled by EMC32

In the Graphics of a Test, is it possible to make the Legend is always on? So we don't need to insert it, every time the Test is finished?

When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?

I am going to migrate EMC32 system in ELEKTRA using the Migration Tool. It seems the Migration Tool has a problem reading the DeviceList.

I am using EMC32 with EMI Auto Test EMC32-K10 and Test Receiver ESCI. The issue is I cannot perform final measurements with the detector CISPR AV.

Updating API macros in EMC32

I recently exported the results table from a test, and realized it had been truncated at line 65535. I tried a few more times, but the result was the same. What is the reason for the limitation?

For radiated emissions test I would like to change the antenna factors to another antenna. Would it be possible to get a step by step guide as to how to create a new radiated emissions test using my EMI Test Receiver receiver with a new antenna?

Using my Turntable the Final Adjustment works on full range (from -180 to +180°) , also if I have defined a "predefined range" of 60°-

R&S EMC32-K27 Dual Receiver Measurement (DRM) - Flyer

FAQ. TS8997 waveform files on the vector generator not found

How to connect HMExplorer to the instrument

We need to be able to send both command one by one. Is it somehow possible?

Diffent from the defaults, I would like to perform a disturbance Power test from eg. 300 to 500cm

I would like to do EMI measurements with a Probe. The thing is that I don’t have a "Probes” section in Device List menu. For instance within this menu, I have Generators, Receivers, etc. but not “Probes”.

Multichannel audio measurements

R&S®EMC32 - Product Brochure

update license iKey 9.xx

Use of ELEKTRA on a non-Test-PC.

FAQ; How to Document Sseveral Measurements in one Test Rreport

EMC32-K2 - how to check for availability

Describes the initial installation and all functions of R&S®ELEKTRA.

EMC32-S: RF indicator while running an EMS test

How can I set up EMC32 so that it is possible to measure with the forward and reverse power with NAP?

EMC32 does come with a Device Support list, available from CD ROM / CD download image, showing the minimum firmware version for my instruments. Is this also available for ELEKTRA?

This application note describes how to use the generic interface in R&S®AdVISE for remote operation.

19-Jun-2020 | AN-No. 1S002

This application note describes how to detect even small fails in dynamic turn indicators with R&S®AdVISE.

30-Jul-2020 | AN-No. 1S006

A typical application is EMS testing with R&S®EMC32 or R&S®ELEKTRA test software. This video shows how R&S®AdVISE can detect artefacts on a dynamic turn indicatore.