21 Results
A sinus signal with i.e. 10 V peak-peak, frequency 1 MHz is applied. If I choose a vertical scale which is too small the peaks of the waveform are not displayed as they are out of range. Now I activate the digital filter in the “Vertical” menu à “Channel”. The frequency of the filter is also set to 1 MHz. Now even at very small vertical scales (i.e. 50 mV/div) the waveform is displayed completely, see screenshot. But the amplitude can not be correct. What goes wrong here?
I am using the ultra segmentation mode to minimize the blind time. But this is not indicated. Is there a way to calculate it?
Export of analog and digital channels of the same acquistion
RTE/RTO/RTP - export of the history into one file with remote commands
RTE/RTO/RTP: Measurement of the level at a designated frequency in FFT with remote commands.
How can I switch between the input impedance of 50 Ohm and 1 MOhm by using SCPI command.
RTE - How can I get the full record length?
Programming examples for oscilloscopes.
We want to measure the voltage of the main line with our oscilloscope.
Number of harmonics, RTE, RTO, Power option, FAQ
At startup of RTE/RTO/RTP Windows asks for user and password. How can I get back the autologon function?
Scaling of frequency measurements RTE, RTO, RTP in cycles/min
FAQ - Decoding of SENT protocoll shows CRC errors
When I use the zoom function to look at the rising edge of a rectangle signal, I see ringing which is not real, see screenshot. What is the reason?
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
I have compared passive and active probes. It seems that the noise with active probes is higher. What is the reason and what can I do to reduce the noise?
Volume Adjustment of the "BEEP"
Connection of R&S ScopeSuite to RTO/RTP fails
RTE/RTO/RTP - Loading a settings file with Labview drivers
Accuracy of RMS Measurements
When I do RMS measurements and an offset is applied, the result changes. I could not see that effect on other scopes. What is wrong here?