9080 Results
I want to switch the impedance to 50 Ohms using remote commands. What is the correct command for that?
What is the calculation base for the sample rate on my R&S RTA / RTM series scope when using FFT?
Is an FSPC license dongle (1310.0002.03) always needed to run the FS-K96 software?
When an additional monitor is connected via the HDMI interface, the touch functionality is lost. How can I get the touch functionality back?
RTM/RTA: Measurement on several pulses of a train.
Calibrating a clamp and creating a transducer table using the R&S ELEKTRA signal path calibration utility
When I do RMS measurements and an offset is applied, the result changes. I could not see that effect on other scopes. What is wrong here?
Tracking Generator
How to read IQ data from Spectrum Analyzer and convert to dBm values
RT-ZVC - Autoranging and gain switching
In the user manual I can find no information about the sample rate of the device. Also I would like to know, which value(s) will be transferred to the software.
Timeout error when connect HMP from FORUM
Use of the ESW build in Pulse Limiter, if remote controlled by EMC32
EMCAN32 (up to EMC32 V10.35) no connection to CANoe 9
I am using the I/O Logging function to write all remote commands sent to the ZNL(E) to file. But I can not find any logging file in the path mentioned in the manual: C:\ProgramData\Rohde-Schwarz\ZNL-FPL\ScpiLogging
Installing a USB-GPIB adapter
I get an unwanted 1 kHz tone in the demodulated AF spectrum after starting the generator in the Expert Mode using dialing. Where does this tome come from?
ROMES update version 3 -> version 4
How can I set up the RTH for correct RS232 / UART decoding?
When I start a calibration with an auto cal unit I get the following warning. What does that mean?