9097 Results
1SL391 audio, breakthrough, ETSI EN 301 489 Audio Breakthrough Assembly and Test Setup 1SL391 audio, breakthrough, ETSI EN 301 489
11-Oct-2022 | AN-No. 1SL391
R&S VCS-4G for simulator and training systems.
18-Jun-2013
FTP Automation Guide with WCDMA Protocol Tester R&S<sup>®</sup> CRTU-W
22-Nov-2007 | AN-No. 1CM68
Conversion Gain Measurements on Mixers with Different Input and Output Impedances
16-May-2002 | AN-No. 1EZ50
Generating and Analyzing CDMA2000 Signals
27-Mar-2001 | AN-No. 1MA34
Get deep insight into your design with a dual-path, precisely synchronized source driving the Doherty amplifier and improve your yield.
12-Jul-2018
Tackling the Challenges of Pulsed Signal Measurements
18-Jan-2008 | AN-No. 1MA124
EMI debugging using fast FFT with MXO oscilloscopes
07-Feb-2024
This application note describes how to use the R&S®RTO, R&S®RTE and R&S®RTM Digital Oscilloscopes for EUT monitoring of signal forms.
20-Apr-2015 | AN-No. 1MA242
This application note explains step by step all necessary settings for transmitting parameters of the disturbance signal from an EMS test to a dAV Camera System via serial port or LAN interface
10-Dec-2019
The R&S®ZNA vector network analyzer with integrated LO output and direct IF input options is a simple, cost-effective solution for 2-port and 4-port measurements using Rohde & Schwarz mmWave converters.
19-Jul-2021
In this paper a rapid characterization of high speed digital channels using a multiport VNA is demonstrated.The VNA is a major tool in the field of communication and signal processing.
18-Mar-2020 | AN-No. 1EZ83_0E
The R&S®EVSG1000 and R&S®EVSF1000 are signal level and modulation analyzers that reliably analyze GBAS systems during ground and flight inspection when used together with the R&S®EVSG-K4 option.
27-Jun-2019
The R&S FSW signal and spectrum analyzer measures and analyzes time sidelobes to optimize compressed radar signals as well as radar hardware components and systems.
22-Oct-2020
Protocol Analysis at Digital Interfaces using the Audio Analyzers UPL and UPD
04-Jun-1998 | AN-No. 1GA15
Replication of real-world RF signals in the lab: Recording, converting and playing back real-world signals
13-Jul-2012
This application note describes how transmitter (Tx) tests (TS25.141 Chapter 6) can be performed quickly and easily by using signal and spectrum analyzers from Rohde & Schwarz.
21-Oct-2014 | AN-No. 1MA67
Air Traffic Control (ATC) radar, military Air Traffic Surveillance (ATS) radar and meteorological radar operate in S-Band frequency range. In fact 4G communication systems such as Long Term Evolution (LTE) make also use of these frequencies.
28-Mar-2014 | AN-No. 1MA211
Calibration Tool for PESQ Speech Quality Tests
30-Jun-2011 | AN-No. 1GA50
Noise figure is an important parameter that describes the noise contribution of an electronic device. A classical approach to measure the noise figure is to use a noise source which delivers two different input noise powers by switching between a “hot” and a “cold” state and a noise receiver
23-Dec-2021 | AN-No. 1SL378
Test solution for multi-antenna EW receivers
22-Dec-2021 | AN-No. 1GP125
The alternative approach presented in this paper employs a low phase noise local oscillator for direct down-conversion of the DUT signal.
09-May-2016
Generation and Analysis of RFID Signals According to ISO 15693
17-May-2006 | AN-No. RSI01
Automatic monitoring of radio signals interfering with sensitive devices in hospitals
04-Sep-2006
R&S AVBrun Conformance testing solution for MHL/HDMI CTS sink/source
14-Sep-2015
This application note describes a technique to perform the noise figure measurement with FSW-K30 on lossy devices like attenuators with high loss in front of the low noise amplifiers.
24-Jun-2020 | AN-No. 1EF110
Additional Tests on CDMA2000® Mobile Stations in Accordance with Standard TIA-98
05-Jan-2012 | AN-No. 1MA86
Using R&S®CMU200 Drivers in Microsoft Visual Studio 2008 with Visual Basic .NET and C#
30-Jun-2009 | AN-No. 1MA157
Generating the Noise Field for Ambient Noise Rejection Tests
12-Oct-2010 | AN-No. 1GA51