I wrote a remote control script for my HMC series instrument which should get the log data I wrote to an external USB stick before. Using "EXT" will throw the error "File name not found". When I take a look at the USB stick on my PC, I can see that it definitely wrote the file to DRIVE:\Data\LOGFILE.CSV.

Trace Export in ASCII Format

Environment tab on EMCAN64

Using WEB Control with the FSW seems to be using ports - which port settings are needed?

Measurement ranges of the LCX series

Can I measure group delay of an Audio ADC or DAC with my UPP / UPV?

Hard disk is not detected

Remote Desktop: How can I see all Analyzer Buttons on the PC Screen?

When I query the waveform with "CHANx:DATA?" the resolution is just that what is displayed on the screen. But I have manually changed the record length to achieve a high resolution. How do I get the data of the waveform with full resolution?

RTE/RTO/RTP - Loading a settings file with Labview drivers

RemoteControl; Smart Instruments; VISA resource name: What is the VISA resource name of the Smart Instruments?

I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.

Crest Factor

When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?

Transferring ASCII trace data by memory card

HM8118 to use external BIAS

HMExplorer installation fails with .dll problems

Marker Demodulation

ZNA/ZNB: Export all mixed mode S-Parameters

Web interface allows several users to control the HMP

I am going to migrate EMC32 system in ELEKTRA using the Migration Tool. It seems the Migration Tool has a problem reading the DeviceList.

Can you tell me a formula to calculate the so called pre arcing time (I²t) to avoid the internal fuse to be blown?

I trigger this single sweep with the RSZVB_Send_Trigger_and_Wait_for_OPC driver, but this driver does not wait for the complete 10 sweeps. If I don't use averaging, this program is works.

I want to control my HMP using the RS-232 port on the HO720. Unfortunately i do not get any response from the device.

ZNB - How to disable Sweep Position Display Symbols

Remote control: Reset the RS-232-C connection

ZVH Wrong offset after calibration

What is the Structure of FSE/FSIQ Trace Data on the GPIB?

IQ data streaming - sample rate conflict if wideband SMW200A is connected to SMBV100A

How can I setup a SPI bus decoding showing MISO and MOSI at the same time as shown on your webpage of the RTC1002?