With version 1.7.20 we made changes to some parameters which lead to incompatibility with elder savesets.

Remote Desktop screen size of ZNB/ZND

The Zoom function does not show any waveform data at specific settings, especially at slower timebases in combination with higher sample rates, High resolution and roll mode with more channels. The problem is gone if a lower sample rate is chosen.

ZNA, ZNB, ZND - Power off after stop of the Sweep?

Most accurate way to measure the length of a cable with a VNA

AC CPL displayed on EMI Receiver.

My HMExplorer script is not running while all commands are OK, why?

I do RMS measurement on a signal after switching the channels. Even with *OPC? or *WAI the result is implausible: 9.91e+37 . How can I get a correct result?

In the manual of your oscilloscopes you state: If AC coupling is set, the attenuation of passive probes has no effect, and voltage is applied to the instrument with factor 1:1

On the screen of my HMO30XX appears “Avg. #2”. What is the meaning of that?

More Battery Capacity Required

Convert the trace data in a dataset file (*.SET) to a CSV file

How to use the 'MODE' , 'Logger' with the scope function in the RTH scope rider

NGP trigger output of different protection state

Interruptions in the RF level when the signal changes

I would like to be sure about the high impedance state of a dedicated channel for my power supply unit. Do you have a process to test and to ensure that? Can you also please explain, how the high impedance mode works?

I want to do a calibration with 75 Ohms at the ZNB/ZND/ZVA. Do these VNAs accept the auto cal unit ZV-Z53 with 75 Ohms impedance?

I am using EMC32 with EMI Auto Test EMC32-K10 and Test Receiver ESCI. The issue is I cannot perform final measurements with the detector CISPR AV.

When looking at the data sheet of the LCX series I can not find any specifications concerning L and C. Where do I find these informations?

ELEKTRA, restart license server

User would like to demodulate a Tetra T1 uplink signal using K70 VSA option in an spectrum analyzer

How can a number of files from the sw 'InstrumentView' be converted to CSV format? How can a number of files from the sw 'InstrumentView' be converted to CSV format?

Adjusting the scaling of the vertical axis

How to connect HMExplorer to the instrument

How to startup your HM8118 using a specific calibration

Reading the magnitude (dB) and phase (degrees) values directly

Calibrating a vector network analyzer (VNA) with different connectors on each port

FAQ; LabWindows/CVI 7.0 Bug

Baud Rate Setting Resets After Power Line Disconnection

I use the oscilloscope in RUN continious mode. When I press "STOP" more than one acquisitions are shown. The waveforms are overlayed. Is there a way to prevent this?