I want to configure the arbitrary function of the waveform generator using CSV files. But I can not find any information about the file format.

Measurement ranges of the LCX series

I tried to generate noise with my SMCV100B. Unfortunately as it is Additional white gaussian noise, I can only add noise to the baseband signal. Is there a way to generate pure noise also?

RTO/RTP Setup of Reference Levels for Measurements in Firmware Version 5

Hard disk is not detected

Meaning of 0dBFS and 0dBr

At old scopes there was no trigger necessary to run the X/Y mode. Why does the mode not work if no valid trigger condition is detected?

EMC32, Level Sweep shape during Reference Calibration

4 Port Calibration with a 2 Port automatic calibration kit possible?

For EMC measurements, I have EZ-17 available, model .02 and model .03. In datasheet "reactive" is specified for the output impedance of model .03. What is the difference between the Model .02 and the Model 03 in terms of EMI measurements?

Remote Desktop: How can I see all Analyzer Buttons on the PC Screen?

RTE/RTO/RTP - Loading a settings file with Labview drivers

I want to set the acquisition mode to Average + HR using SCPI commands. But I can not find the right command in the manual.

RemoteControl; Smart Instruments; VISA resource name: What is the VISA resource name of the Smart Instruments?

I am using the command “CONT:AUX:C x” to see when a channel is active. But the respective pin at the AUX connector does not switch to “high”.

Learn how one can find the CSA certificate number of an Rohde & Schwarz instrument.

EMC32, display preview results of all LISN phases

I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.

When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?

FAQ: How to get an Overview of Several Curves in one Diagram?

The signal generator come in different frequency ranges. Using a program is there a way to tell the frequency range of the SMB100A for example?

Transferring ASCII trace data by memory card

HMExplorer installation fails with .dll problems

I want to export the waveform data of my RTO scope into MATLAB, but the only way I found so far is the screenshot option. Is there another way to use the trace data in my script?

HM8118 to use external BIAS

Marker Demodulation

FPC1000 and FPC1500: "Auto Power Up on AC" does not work correct

ZNA/ZNB: Export all mixed mode S-Parameters

These are the steps to perform the desired measurement.

I have a R&S Laboratory Power Supply and could find not find a way to make it switch on the output automatically after mains comes up. How can this be done?