Search

ZVH: How to generate Touchstone S2P files?

How to generate Touchstone S2P files.

HMC8015 - Exteneded Measurement in Compliance Tests

HMC8015 - Exteneded measurement in compliance tests.

FSP and FS-K3

How can the Digital Voltmeter be reactivated?

Computer Name: Default computer name

FAQ; AFQ100A; AFQ100B; Computer Name: Default computer name

Connection of DUT and Link partner with test fixture RT-ZF2

How to check the internal Calibration Source?

Are the Settings Questionable?

Are the settings questionable?

Remote Access to CMW via WiFi / WLAN

How can a WiFi connection instead be made to a WiFi network for remote access of the CMW?

AMS32, special result files with the extension "_raw"

How to check the available memory space?

HMC804x: Frequency of switching regulator

Can you please let us know where the switching frequency of the HMC804x family is located? We observe signals at about 80 kHz and want to be sure if it comes from the PSU or not.

Remote Control of power head: I do not get a response on the 'FETCh?' command

EMC32, frequency ranges in Subrange Maxima search

Reference Calibration using ELEKTRA and Field Probe, repeat measurement for a sensor position

I would like to do a Reference Calibration using ELEKTRA and Field Probe. For this I have to do Reference Calibrations at 16 positions, this does mean my Field Probe have to be set to each of the 16 predefined points. I set the probe positions manually, so an error can occur by mistake. Is it possible to repeat a measurement for a sensor position, if needed?

The Marker does not show the exact Frequency

Fault messages / error codes at (blue) IMP pumps

NRT2 Remote control

I want to remote control my NRT2.

Calibration with Auto Cal Kits and inserted attenuators

ESU/FSQ with Windows XP has "Registry File Failure"

Installation

ROMES: Installation

Matlab: Remote Control example for NRP-Zxx power sensors with NI-VISA

FPC1500 - results after calibration in VNA mode

Is it possible to migrate my EMC32 templates to ELEKTRA?

I am existing EMC32 customer. It is possible to migrate my EMC32 templates to ELEKTRA?

Bode plot measurement - when is it finished

How can I find out that the measurement has been finished?

Number of harmonics in RTE/RTO Power option

Number of harmonics, RTE, RTO, Power option, FAQ

TS8997 waveform files on the vector generator not found

FAQ. TS8997 waveform files on the vector generator not found

UNCAL message after manual changes in the Coupling menu

Unable to launch Elektra, re-install with clean up

How to use the binning function for component sorting

I want to use the LCX series LCR Meter to automatically control and sort components. One of the tasks is to differentiate between the following three values of resistors: - Less than 990 Ohm, - Middle range from 990 to 1010 Ohm (1 kOhm), - More than 1010 Ohm. How can I set this measurement up and which pins do I have to use at the 15 PIN SUB-D socket at the rear side of the LCX?