How can I add a attenuation table to my cable, used in my measurement setup?

Use of the ESW build in Pulse Limiter, if remote controlled by EMC32

In the Graphics of a Test, is it possible to make the Legend is always on? So we don't need to insert it, every time the Test is finished?

When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?

I am going to migrate EMC32 system in ELEKTRA using the Migration Tool. It seems the Migration Tool has a problem reading the DeviceList.

I am using EMC32 with EMI Auto Test EMC32-K10 and Test Receiver ESCI. The issue is I cannot perform final measurements with the detector CISPR AV.

Updating API macros in EMC32

I recently exported the results table from a test, and realized it had been truncated at line 65535. I tried a few more times, but the result was the same. What is the reason for the limitation?

For radiated emissions test I would like to change the antenna factors to another antenna. Would it be possible to get a step by step guide as to how to create a new radiated emissions test using my EMI Test Receiver receiver with a new antenna?

Using my Turntable the Final Adjustment works on full range (from -180 to +180°) , also if I have defined a "predefined range" of 60°-

FAQ. TS8997 waveform files on the vector generator not found

R&S EMC32-K27 Dual Receiver Measurement (DRM) - Flyer

How to connect HMExplorer to the instrument

We need to be able to send both command one by one. Is it somehow possible?

Diffent from the defaults, I would like to perform a disturbance Power test from eg. 300 to 500cm

I would like to do EMI measurements with a Probe. The thing is that I don’t have a "Probes” section in Device List menu. For instance within this menu, I have Generators, Receivers, etc. but not “Probes”.

Multichannel audio measurements

R&S®EMC32 - Product Brochure

update license iKey 9.xx

Use of ELEKTRA on a non-Test-PC.

FAQ; How to Document Sseveral Measurements in one Test Rreport

EMC32-K2 - how to check for availability

EMC32-S: RF indicator while running an EMS test

Describes the initial installation and all functions of R&S®ELEKTRA.

How can I set up EMC32 so that it is possible to measure with the forward and reverse power with NAP?

EMC32 does come with a Device Support list, available from CD ROM / CD download image, showing the minimum firmware version for my instruments. Is this also available for ELEKTRA?

This application note describes how to use the generic interface in R&S®AdVISE for remote operation.

19-Jun-2020 | AN-No. 1S002

This application note describes how to detect even small fails in dynamic turn indicators with R&S®AdVISE.

30-Jul-2020 | AN-No. 1S006

A typical application is EMS testing with R&S®EMC32 or R&S®ELEKTRA test software. This video shows how R&S®AdVISE can detect artefacts on a dynamic turn indicatore.

A typical application is EMS testing with R&S®EMC32 or R&S®ELEKTRA test software. This video shows how to use R&S®AdVISE to monitor noise and audio emission of EUTs. EMC; EMS; EMS Testing; EMC Testing; EMC32; ELEKTRA; AdVISE; Visual Inspection; Optical Inspection R&S®AdVISE visual inspection software automates the process of visually monitoring equipment under test (EUT) during a test sequence.