34 Results
RTM/RTA: Measurement on several pulses of a train.
What is the calculation base for the sample rate on my R&S RTA / RTM series scope when using FFT?
When I set the frequency of the arbitrary generator to 10 KHz, the frequency of the output signal is 120 KHz. What is wrong here?
I am using the burst function of the function generator. But I can not find the remote command to set the burst to "manual".
I have compared passive and active probes. It seems that the noise with active probes is higher. What is the reason and what can I do to reduce the noise?
I want to use the "Remote Display" function of the Instrument View software. Instead of the screen I just see a "white" area. My PC is connected via USB. How can I use it?
Saving a screenshot to an USB stick with remote commands
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
Configuring the Probe Adapter RT-Z2T with remote commands
I have saved some important screenshots in /INT/SCREEN path. Now I want to save/copy these data on a USB key or my PC.
How can I copy the screen shots from the internal memory to an USB stick?
With active FFT it seems that the timebase setting can not be changed. Is there a way to do that?
I made some power measurements using my R&S RTA4004 that lead to questionable power results. What can I do to improve my results?
At old scopes there was no trigger necessary to run the X/Y mode. Why does the mode not work if no valid trigger condition is detected?
Cursors that follow the waveform
When I query the waveform with "CHANx:DATA?" the resolution is just that what is displayed on the screen. But I have manually changed the record length to achieve a high resolution. How do I get the data of the waveform with full resolution?
I want to set the acquisition mode to Average + HR using SCPI commands. But I can not find the right command in the manual.
Programming examples for oscilloscopes.
We want to measure the voltage of the main line with our oscilloscope.
No synchronisation in Auto Trigger Mode
RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA, RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA,
I would like to measure the voltage at a certain time of a captured waveform. Do I need to use the cursor function? May I ask for the SCPI commands?
How can I query the waveform data of the serveral segments?
RTB/RTM/RTA - reduce Stop Frequency at FFT
How can I switch between the input impedance of 50 Ohm and 1 MOhm by using SCPI command.
LabView Driver rsrtx - Range of Configure Trigger Channel Level
How can I find out that the measurement has been finished?
I want to install the RTB / RTM / RTA into a rack and I use the rackmount kit "ZZA-RTB2K". Is the ground of the oscilloscope then connected to the frame of the rack?
TM/RTA - Edge A/B Trigger - Remote commands for the trigger level
I do RMS measurement on a signal after switching the channels. Even with *OPC? or *WAI the result is implausible: 9.91e+37 . How can I get a correct result?
RTB, RTM, RTA: Acquire Mode "High Resolution" looses details?
To measure the time between the pulses I need a slow time base of 200 ms/div. Is there a way to get them visible with new scopes?
I use the oscilloscope in RUN continious mode. When I press "STOP" more than one acquisitions are shown. The waveforms are overlayed. Is there a way to prevent this?
Delta Time Accuracy Calculation for my Oscilloscope