Download Center

The EZ-17 has a 12 pin connector

Most accurate way to measure the length of a cable with a VNA

RTO/RTP - Zoom Windows does not show waveform data

The Zoom function does not show any waveform data at specific settings, especially at slower timebases in combination with higher sample rates, High resolution and roll mode with more channels. The problem is gone if a lower sample rate is chosen.

ZNA, ZNB, ZND - Power off after stop of the Sweep?

HMC8012: Measurement of data stream

Does the HMC8012 support to send the measurement data automatically as some kind of a stream?

AC CPL displayed on EMI Receiver.

Delta Time Accuracy Calculation for my Oscilloscope

My HMExplorer script is not running while all commands are OK, why?

HMO30XX - What does "Avg. #2" mean?

On the screen of my HMO30XX appears “Avg. #2”. What is the meaning of that?

Connecting Power Sensors

Connecting power sensors

SMW200A SMW-K355 SMW-K130 SMW-K430 OneWeb Options - Firmware Extension + Pre-requirments

After the Keycode installation for the OneWeb Options SMW-K130, SMW-K355 and SMW-K430, the waveforms are not present on the SMW200A.

Is the auto cal unit ZV-Z53 with 75 Ohms accepted from ZNB/ZND/ZVA?

I want to do a calibration with 75 Ohms at the ZNB/ZND/ZVA. Do these VNAs accept the auto cal unit ZV-Z53 with 75 Ohms impedance?

Switch cycles of the HMP Series

In the datasheet of the HMP series i could not find any information concerning the MTBF time of the relay switching the output power. Do you have any further information available?

Hi Impedance Mode for Power Supplies (e.g. NGP800)

I would like to be sure about the high impedance state of a dedicated channel for my power supply unit. Do you have a process to test and to ensure that? Can you also please explain, how the high impedance mode works?

How to determine the accuracy for L and C with the R&S LCX series LCR Meters

When looking at the data sheet of the LCX series I can not find any specifications concerning L and C. Where do I find these informations?

Logging time accuracy HMC8015

I use my HMC8015 to log the measurement over a longer time. Can you please specify the logging time accuracy for the HMC8015 Power Analyzer? How stable is the time base?

Installing and using multiple versions of ELEKTRA

How to install multiple version of ELEKTRA.

How to Create a User-Defined PRESET

How can I create a log file of the R&S VISA traffic?

Some parts of my program cause timeouts. Is it possible to track the traffic via my VISA installation? It would help me a lot to see the complete command flow including timing information

FSH: Store measurement result as S2P Touchstone file

Adjust the display brightness of the screen of the FPL

How to adjust the display brightness of the screen of the FPL

Remote desktop: How to show the front panel buttons?

Remote desktop: Remote desktop: How to show the front panel buttons?

RSTW - VI_EMI_pretest_solution_CN

經濟款EMI預測試解決方案

RSTW - VI_EMI_pretest_solution_CN

Supplementary Terms for Trainings

These Supplementary Training Terms shall apply in addition to R&S General Conditions for Deliveries and Services for Use in Transactions with Business Customers.

Supplementary Terms for Trainings

RSJ Traceability Chart REV5.4e

RSJ Traceability Chart REV5.4e Brochures and Data Sheets Miscellaneous

RSJ Traceability Chart REV5.4e

Over-the-air testing of automotive communication systems at vehicle level