Download Center

The newly installed UPV-B42 option does not work. What could be wrong?

Reference Calibration using ELEKTRA and Field Probe, repeat measurement for a sensor position

I would like to do a Reference Calibration using ELEKTRA and Field Probe. For this I have to do Reference Calibrations at 16 positions, this does mean my Field Probe have to be set to each of the 16 predefined points. I set the probe positions manually, so an error can occur by mistake. Is it possible to repeat a measurement for a sensor position, if needed?

NRT2 Remote control

I want to remote control my NRT2.

Impedance measurement of non 50 Ohm cable

Software to capture screenshots or trace data on a PC?

RTB/RTM/RTA: Other units than V or A at channels?

RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA, RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA,

FPC Series - how to change the working directory to a sub directory on a USB stick

I tried to change the working directory on my FPC series analyzer without success. It stays to "\Public" all the time. Can you explain how to set the desired directory?

The measurement range does not fit using a sensor

Calibration with Auto Cal Kits and inserted attenuators

R&S ELEKTRA, ESH3-Z2 Pulse Limiter's Transducer Factor Entry

I am using R&S ELEKTRA with EMI Receiver for conducted measurements with a LISN. During installation and first measurement, we had the "IFOVLD" error, what does mean results are invalid.

EMC32, Slidebar minimum position and maximum position

Diffent from the defaults, I would like to perform a disturbance Power test from eg. 300 to 500cm

TS8997 waveform files on the vector generator not found

FAQ. TS8997 waveform files on the vector generator not found

Noise Floor below 3 MHz

UNCAL message after manual changes in the Coupling menu

Unable to launch Elektra, re-install with clean up

EVS Bandwidth Indicator VoLTE and VoWiFi call on CMW500/CMW290 user interface

During the call setup with VoLTE/VoWiFi with EVS voice codec the bandwidth is negotiated. How can the bandwidth be setup and how will it be shown in the CMW user interface?

Red CAL Sign in the Display is on

[LBS NG] LTE Attach Issue on TDD 39

Correct Step Size for a Stepped EMI Scan?

How to Connect the Control Cable from the FSP-B10 (ext. Generator Control) to the SMU200A?

External reference locking range

I have found two informations reagarding the external reference for my signal Generator. One is the frequency locking range in the specifications.

EMC32, Download Transducer Factor to Test Receiver

How to get eSIM / eUICC test profile for build-in eSIM / eUICC cards

How to get eSIM / eUICC test profile for build-in eSIM / eUICC cards.

ATE TMO v20.40/20.4x patch status and known issues

Hardware setup for EMI automotive band evaluation?

Configuring Maturo Type Antenna Controllers and Similar Devices in EMC32