16 Results
CMW500/2xx intenal fan settings to reduce noise CMW500/2xx intenal fan settings to reduce noise
How can the external attenuation values be configured and embedded in the CMWRun test sequences?
How to get Wireshark log files for IMS (VoLTE, VoWiFi) when using CMW500/CMW290
Setting a CMW as a Bluetooth LE packet Generator
The CMW500/2xx shows a resource conflict in this situation when using in parallel the RFxCOM port and the RFxOUT port of the same RF-frontend.
How can the CQI (Chanel Quality Identifier) from UE and coresponding 3GPP specified mapping to Modulation and TBS be tested?
Is it possible to set up an IP peer to peer test using CMW500 between a corporate network and one EUT attached to an LTE cell?
During the call setup with VoLTE/VoWiFi with EVS voice codec the bandwidth is negotiated. How can the bandwidth be setup and how will it be shown in the CMW user interface?
CMWrun Settings for external Interfer usage in Bluetooth LE Test Plans.
CMsquares download file not available in R&S Installation Manager
LTE UE capabilities Interpretation of Bandwidth Combination Set values shown in CMW Callbox
During a CMWrun test my DUT fails on delivering isolated measurements using CMW270/290/500.
Installation of CMWcards is made on a external PC that should control the CMW mobile radio tester via LAN interface. But also the PC and the CMW are connected to the same LAN the remote connection do not work and the resource check showed "not connected".
CMW500/290/270: No more WLAN signaling function after WLAN firmware update
DTMF analysis on CMW500 and CMW290
It is required to run two simultaneous NB IoT Signaling tests in parallel. Is this possible for a CMW call box tester?