9099 Resultados
I am using the I/O Logging function to write all remote commands sent to the ZNL(E) to file. But I can not find any logging file in the path mentioned in the manual: C:\ProgramData\Rohde-Schwarz\ZNL-FPL\ScpiLogging
Quiero usar mi ZNA como un generador de señales diferenciales puro para obtener una señal de onda continua constante.
HMO1002 / RTC1002 USB TMC connection
ELEKTRA Remote Control, Test Receiver does not show Limit Line and Transducer
FAQ: Uso de celdas GTEM individuales
Ejemplos de programación del CMA180
Amplificador genérico EMC32, diferentes maneras de enviar comandos SCPI en secuencia
I perform a calibration with remote commands. With the command to start the calibration sweep with a short standard I get this error message. What is the problem?
He conectado mi sensor NRP al CMA180. Sin embargo, no se encuentra al abrir la pestaña «sensor». ¿Qué puedo hacer para que funcione el sensor?
FSW - How to find the accessories for a device.
Cómo transferir automáticamente datos I/Q del analizador de espectro R&S®FSVR al software VSE
Filtro
How can the transducer be imported from Excel into the InstrumentView software?
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
¿Cómo puedo exportar las trazas de un canal específico a un archivo, p. ej. un CSV?
How to get the HM8118 to provide the Q factor via remote control How to get the HM8118 to provide the Q factor via remote control
Tengo una fuente de alimentación de la serie R&S HMP. ¿Podrían indicarme cómo puede leer las versiones de firmware, especialmente para la tarjeta de interfaz?
Remote readout of 2nd function at the HMC8012
ZNB/ZND – En la caracterización de la unidad de calibración se muestra un tipo de conector incorrecto
He constatado que no todas las opciones del receptor de pruebas se muestran en la lista de dispositivos de ELEKTRA. Por ejemplo, la opción FSL-B7 no se muestra en la lista de dispositivos. ¿Es esto importante?
Cómo lograr un nivel de ruido por debajo de -100 dBm para medidas de S21
I use the HMF2550 as a Sinus generator in combination with AM modulation. The power level of my modulated signal is too low. If I switch off modulation (pure CW) the signal level is fine again. What's the background of this behavior?
Impresión de traza negra sobre fondo blanco
Cómo obtener archivos de registro Wireshark para IMS (VoLTE, VoWiFi) utilizando el CMW500/CMW290
I would like to connect a controller with EMC32 program and measure the disturbance field strength with at a certain distance in sync with motorised rail. I would like to setup the communication between my controller and EMC32. Can you send me some instructions for communication between EMC32 and external hardware?
Saving a screenshot to an USB stick with remote commands
¿Cuál es el ancho de banda del voltímetro digital?
Autocalibración por control remoto con una unidad de calibración
Generador de tracking
Calibrating a clamp and creating a transducer table using the R&S ELEKTRA signal path calibration utility