26 Results
RTB, RTM, RTA: Acquire Mode "High Resolution" looses details?
I do RMS measurement on a signal after switching the channels. Even with *OPC? or *WAI the result is implausible: 9.91e+37 . How can I get a correct result?
Delta Time Accuracy Calculation for my Oscilloscope
I use the oscilloscope in RUN continious mode. When I press "STOP" more than one acquisitions are shown. The waveforms are overlayed. Is there a way to prevent this?
Is is possible to use the differential probes RT-ZD02 or RT-ZD08 on oscilloscopes with high impedance? The impedance of the RT-ZD02/ZD08 is 50 Ohms.
How to store results on a local PC from a RTB connected via LAN.
I want to install the RTB / RTM / RTA into a rack and I use the rackmount kit "ZZA-RTB2K". Is the ground of the oscilloscope then connected to the frame of the rack?
Programming examples for oscilloscopes.
We want to measure the voltage of the main line with our oscilloscope.
RTB/RTM/RTA - reduce Stop Frequency at FFT
When I set the frequency of the arbitrary generator to 10 KHz, the frequency of the output signal is 120 KHz. What is wrong here?
When I query the waveform with "CHANx:DATA?" the resolution is just that what is displayed on the screen. But I have manually changed the record length to achieve a high resolution. How do I get the data of the waveform with full resolution?
RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA, RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA,
I would like to measure the voltage at a certain time of a captured waveform. Do I need to use the cursor function? May I ask for the SCPI commands?
No synchronisation in Auto Trigger Mode
With active FFT it seems that the timebase setting can not be changed. Is there a way to do that?
I have saved some important screenshots in /INT/SCREEN path. Now I want to save/copy these data on a USB key or my PC.
I want to use the "Remote Display" function of the Instrument View software. Instead of the screen I just see a "white" area. My PC is connected via USB. How can I use it?
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
LabView Driver rsrtx - Range of Configure Trigger Channel Level
How can I query the waveform data of the serveral segments?
How can I query the status of the trigger with remote commands?
Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000 Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000
How can I find out that the measurement has been finished?
At old scopes there was no trigger necessary to run the X/Y mode. Why does the mode not work if no valid trigger condition is detected?
Saving a screenshot to an USB stick with remote commands