26 Results
I have saved some important screenshots in /INT/SCREEN path. Now I want to save/copy these data on a USB key or my PC.
With active FFT it seems that the timebase setting can not be changed. Is there a way to do that?
Saving a screenshot to an USB stick with remote commands
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
I want to use the "Remote Display" function of the Instrument View software. Instead of the screen I just see a "white" area. My PC is connected via USB. How can I use it?
LabView Driver rsrtx - Range of Configure Trigger Channel Level
I would like to measure the voltage at a certain time of a captured waveform. Do I need to use the cursor function? May I ask for the SCPI commands?
No synchronisation in Auto Trigger Mode
How can I find out that the measurement has been finished?
RTB/RTM/RTA - reduce Stop Frequency at FFT
We want to measure the voltage of the main line with our oscilloscope.
When I set the frequency of the arbitrary generator to 10 KHz, the frequency of the output signal is 120 KHz. What is wrong here?
When I query the waveform with "CHANx:DATA?" the resolution is just that what is displayed on the screen. But I have manually changed the record length to achieve a high resolution. How do I get the data of the waveform with full resolution?
Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000 Calibration certificate? Calibration certificate; ZNL; ZNLE; FTP1000; RTH1000; RTB2000; ZPH; FPH; FPC1000; RTM3000
Programming examples for oscilloscopes.
RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA, RTB/RTM/RTA: Other units than V or A at channels? RTB, TRM, RTA,
How can I query the waveform data of the serveral segments?
How can I query the status of the trigger with remote commands?
How to store results on a local PC from a RTB connected via LAN.
Delta Time Accuracy Calculation for my Oscilloscope
I do RMS measurement on a signal after switching the channels. Even with *OPC? or *WAI the result is implausible: 9.91e+37 . How can I get a correct result?
I want to install the RTB / RTM / RTA into a rack and I use the rackmount kit "ZZA-RTB2K". Is the ground of the oscilloscope then connected to the frame of the rack?
Is is possible to use the differential probes RT-ZD02 or RT-ZD08 on oscilloscopes with high impedance? The impedance of the RT-ZD02/ZD08 is 50 Ohms.
At old scopes there was no trigger necessary to run the X/Y mode. Why does the mode not work if no valid trigger condition is detected?
RTB, RTM, RTA: Acquire Mode "High Resolution" looses details?
I use the oscilloscope in RUN continious mode. When I press "STOP" more than one acquisitions are shown. The waveforms are overlayed. Is there a way to prevent this?