24 Risultati
Regolazione del volume del “BEEP”
When I do RMS measurements and an offset is applied, the result changes. I could not see that effect on other scopes. What is wrong here?
La sequenza SCPI per la configurazione e l'interrogazione dei dati per l'opzione K11 dell'interfaccia software I/Q.
Collegamento del dispositivo in prova e del partner di collegamento con l’attrezzatura di prova RT-ZF2
Ho confrontato sonde passive e attive. Sembra che con le sonde attive il rumore sia maggiore. Qual è il motivo e cosa posso fare per ridurre il rumore?
Cambio scale delle misure di frequenza con gli oscilloscopi RTE, RTO, RTP in cicli/min
Collegando un monitor esterno tramite l'interfaccia HDMI, si perde la funzionalità touch. Come posso ripristinare tale funzionalità?
FAQ - Decoding of SENT protocoll shows CRC errors
R&S Scope Suite - Test di conformità eMMC non riuscito
Quando utilizzo la funzione di zoom per osservare il fronte di salita di un segnale rettangolare, vedo un'interferenza che non è reale, vedere la schermata. Perché?
I have exported the waveform into a csv file. When I open the file in Excel, the values are completely wrong. How can I get correct values?
For some tests a vector network analyzer is required. The Scope Suite software just supports VNAs from R&S to be connected via LAN for automated measurements. Can I use also other VNAs and do the measurement manually?
All'avvio di RTE/RTO/RTP Windows richiede utilizzatore e password. Come posso ripristinare la funzione autologon?
RTO / RTP Firmware Update from an older Version
Is it possible to do math operations on a measurement? For example measure the frequency but display the result as cycles per minute?
RTE/RTO/RTP: Misura del livello a una frequenza designata nella FFT con comandi remoti.
Which test fixture for MDI mode conversion measurement at 100Base T1 Compliance Test?
Configurazione degli oscilloscopi RTO/RTP: livelli di riferimento per le misure nella versione 5 del firmware
RTE/RTO/RTP - Caricamento di un file di impostazioni con i driver di Labview
A sinus signal with i.e. 10 V peak-peak, frequency 1 MHz is applied. If I choose a vertical scale which is too small the peaks of the waveform are not displayed as they are out of range. Now I activate the digital filter in the “Vertical” menu à “Channel”. The frequency of the filter is also set to 1 MHz. Now even at very small vertical scales (i.e. 50 mV/div) the waveform is displayed completely, see screenshot. But the amplitude can not be correct. What goes wrong here?
Sto utilizzando la modalità di ultra segmentazione per ridurre al minimo il tempo cieco. Ma questo non è indicato. Esiste un modo per calcolarlo?
The Zoom function does not show any waveform data at specific settings, especially at slower timebases in combination with higher sample rates, High resolution and roll mode with more channels. The problem is gone if a lower sample rate is chosen.
Esempi di programmazione per oscilloscopi.
RTE/RTO/RTP - esportazione della cronologia in un unico file con comandi remoti