22 결과
ZNB/ZND/ZVA에서 75 Ohms로 calibration을 수행하고 싶습니다. 이 벡터 네트워크 분석기에서 75 Ohms의 ZV-Z53 자동 calibration unit을 사용할 수 있습니까?
scpi 명령어를 사용하여 트레이스 값의 쿼리를 실행하는데, y값만 도출됩니다. x값(주파수)도 얻을 방법이 있나요?
이미 사용 중인 리미트 라인이 있습니다. 여기에 수직 오프셋을 적용할 수 있습니까?
How do I calculate these frequency points when I have a logarithmic sweep and know the center frequency, the span and the number of sweep points?
장치에 파일이 있습니다. PC로 간단하게 파일을 옮기는 방법은 무엇인가요?
Export complex data of a trace with mathematics and time gating.
첨부된 PDF 문서에서 도구 설치 방법과 HMP 전력 공급 장치의 원격 연결을 위한 설정 방법을 확인하실 수 있습니다.
한 개 채널에 마커가 있는 트레이스가 여러 개 있습니다. 마커 1의 결과를 쿼리하면 언제나 트레이스 1의 응답이 나옵니다. 트레이스 2에 대한 마커 1의 결과를 얻으려면 어떻게 하나요?
ZNA, ZNB, ZND - 스윕 완료 후 출력 종료 여부
ZNA/ZNB: Export all mixed mode S-Parameters
Is it possible to automatically restart a ZNB with return of the AC power?
ZNA를 연속적인 CW 신호를 생성하는 트루 디퍼런셜 신호 발생기로 사용하고 싶습니다.
활성 교정 키트 또는 교정 유닛에 선택한 교정 절차에 필요한 모든 표준이 포함되지 않았습니다(Active cal kit or cal unit does not contain all standards needed for selected cal procedure).
벡터 네트워크 분석기(VNA)에서 컨트롤러 PC 또는 네트워크 드라이브로 결과를 전송하려고 합니다.
VNA - 교정에 슬라이딩 매치가 꼭 필요한가요?
When I export the time domain trace the stimulus values are in Hz, but not in seconds as shown on the screen. How can I get the export in time or distance?
모든 트레이스 데이터 쿼리를 한 번에 실행하는 방법이 있나요?
I perform a calibration with remote commands. With the command to start the calibration sweep with a short standard I get this error message. What is the problem?
특정 채널의 트레이스를 하나의 파일(예: CSV)로 내보내려면 어떻게 해야 하나요?
I got a calibration kit with a sliding match standard. But there are no correction values for the NWA supplied.
Calibration of two channels simultaneously with remote commands
ZNA/ZVA - ZCxxx 컨버터 설치 방법