9017 Results
At old scopes there was no trigger necessary to run the X/Y mode. Why does the mode not work if no valid trigger condition is detected?
EMC32, Level Sweep shape during Reference Calibration
4 Port Calibration with a 2 Port automatic calibration kit possible?
For EMC measurements, I have EZ-17 available, model .02 and model .03. In datasheet "reactive" is specified for the output impedance of model .03. What is the difference between the Model .02 and the Model 03 in terms of EMI measurements?
Remote Desktop: How can I see all Analyzer Buttons on the PC Screen?
RTE/RTO/RTP - Loading a settings file with Labview drivers
I want to set the acquisition mode to Average + HR using SCPI commands. But I can not find the right command in the manual.
RemoteControl; Smart Instruments; VISA resource name: What is the VISA resource name of the Smart Instruments?
I am using the command “CONT:AUX:C x” to see when a channel is active. But the respective pin at the AUX connector does not switch to “high”.
Learn how one can find the CSA certificate number of an Rohde & Schwarz instrument.
EMC32, display preview results of all LISN phases
I have used my TRL calibration kit with my ZVA before. Now I want to use also with my ZNB. But when I try to load the data of the calibration kit into the ZNB, the above error message is shown.
When I run the Test and go back to change the parameters in Test Template, how do I save the new settings?
FAQ: How to get an Overview of Several Curves in one Diagram?
The signal generator come in different frequency ranges. Using a program is there a way to tell the frequency range of the SMB100A for example?
Transferring ASCII trace data by memory card
HMExplorer installation fails with .dll problems
I want to export the waveform data of my RTO scope into MATLAB, but the only way I found so far is the screenshot option. Is there another way to use the trace data in my script?
HM8118 to use external BIAS
Marker Demodulation
FPC1000 and FPC1500: "Auto Power Up on AC" does not work correct
ZNA/ZNB: Export all mixed mode S-Parameters
These are the steps to perform the desired measurement.
I have a R&S Laboratory Power Supply and could find not find a way to make it switch on the output automatically after mains comes up. How can this be done?
This article describes the typical questions and considerations to be done while handling SIM Cards and using R&S instruments such as for example CMW500.
Transmission measurements without tracking generator
How to install a LabView driver
Amplifier Change in R&S transmitters XX8000 with NetCCU800
Can you tell me a formula to calculate the so called pre arcing time (I²t) to avoid the internal fuse to be blown?
I trigger this single sweep with the RSZVB_Send_Trigger_and_Wait_for_OPC driver, but this driver does not wait for the complete 10 sweeps. If I don't use averaging, this program is works.