9011 Results
Remote Control: Change the byte order in FORMAT REAL
I want to use the LCX series LCR Meter to automatically control and sort components. One of the tasks is to differentiate between the following three values of resistors: - Less than 990 Ohm, - Middle range from 990 to 1010 Ohm (1 kOhm), - More than 1010 Ohm. How can I set this measurement up and which pins do I have to use at the 15 PIN SUB-D socket at the rear side of the LCX?
What is the Structure of FSE/FSIQ Trace Data on the GPIB?
I want to set the trigger source of my FSMR to AM. But it always sets the trigger source to RF level. How can I set the trigger source to AM ?
How can I save the complete device information of my CMA 180 to a USB stick?
Does the option ZNA-K1 (Spectrum analyzer mode) also work with the Millimeterwave Converters?
Self Alignment via remote control via TCP/IP => 'CAL?
Single Pulse via the HMF2525/HMF2550 Signal Generator by using the enter key as a trigger source Single Pulse via the HMF2525/HMF2550 Signal Generator by using the enter key as a trigger source
FAQ, Compatible Firmware Versions
Scope Rider answers to a IP address which has not been entered.
FAQ AMS32 Signal Path Calibration, ensure that valid CAL Data are loaded on the OTA Network Analyzer
FAQ: Check EMC32 Expansions
How can I set the special slot format in 5G NR measurement application for TDD?
Unfortunately I can control my NRP-Z sensor only from the VisaTester but not from my Python IDE when using the same Device Identifier "USB::0x0aad::0x0023::102800::INSTR". What is wrong?
This summary intends to give a fast overview for generation and verification of FM chirp signals using R&S Instruments and software Tools.
I want to use Port 1 and Port 3, so I tried to switch them on by setting the value to 1 (the default value) and to switch off Port 2 and Port 4 by setting the value to 0. But this does not work. How do I set the ports?
Active cal kit or cal unit does not contain all standards needed for selected cal procedure.
Scope Rider RTH: How to query when a trigger occured?
No synchronisation in Auto Trigger Mode
RTB/RTM/RTA - reduce Stop Frequency at FFT
How to generate separate graphics for the horizontal and vertical result using EMC32-EB
I have set my VNA to single sweep mode and switched on averaging with a factor of 10. But when I restart the single sweep, it stops after 1 sweep and the averaging is not done.
The SCPI sequence for configuration and data query for the I/Q software interface option K11.
Multichannel audio measurements
Why is it helpful to do Data Reduction?
Single Sweep
Location of the instrument Drivers
FAQ: How can I generate and Export a Test Rreport?
How to enable Telnet Client in Windows 7
Example on how to manually generate a *.wv file with Python